Wireless Home  (490-2010)  Removing Sensors/Detectors   Faxback Doc. # 8916
Alarm System

Follow these steps to remove an existing door/window transmitter or smoke
alarm siren detector from the system.

1.  Press LEARN on the base to enter the learn mode.  Then enter your
    personal access code.

2.  Enter the zone number for the device you want to remove.  The
    corresponding zone indicator flashes.

Note:  If you decide not to remove the device for the zone you selected,
       enter another zone number.

3.  Press CANCEL while the zone indicator flashes.  The indicator turns
    off.

4.  Press CANCEL again to exit the learn mode.

Adding or Removing a Remote Control

Follow these steps to add or remove a remote control from the system.

1.  Press LEARN.  The LEARN indicator flashes.

2.  Enter your personal access code.  The LEARN indicator lights steadily.

3.  Press any two keys on the new remote control at the same time.  The
    base sounds a short tone to confirm the addition or removal of the
    remote control.

Note:  There is no visual indication to confirm the addition or removal of
       a remote control.

4.  Repeat Step 3 for each remote control you add or remove.

5.  Press CANCEL to exit the learn mode.

Note:  You can have up to four remote controls with this system.  When you
       add a new remote control to the system, the system clears all the 
       settings of existing remote controls from memory.  This lets you
       disable a lost or missing remote control.  Each time you add a new
       remote control, you must perform Step 3 for all remote controls to 
       allow the base to relearn the remote controls.

(SMC/jlc-03/22/94)