DWP 2  (260-1158)        Operating Instructions        Faxback Doc. # 4648

LOADING PAPER

1. Release the Paper Bail Lever from the Platen by pulling forward.

2. Insert paper down behind the Platen, and roll the Platen by hand to 
   bring  the paper around the platen and up in front.

3. Pull the Paper Release Lever forward to release platen pressure to aid 
   in proper paper alignment.

4. Align and position the paper at the left hand margin.

5. While holding the paper in the proper position, return the Paper Re-
   lease Lever to its operating position.

6. Return the Paper Bail Lever to its operating position to apply platen  
   pressure on the Paper.

7. While pushing the right hand platen knob, roll the platen to position 
   paper precisely for printing.

COPY CONTROL (PAPER THICKNESS ADJUSTMENT)

The left hand copy control lever is for the type and thicknesses of paper 
to be printed. Four detent positions are provided on the copy control 
lever. This lever should be in the first detent position (fully forward) 
when printing single thicknesses of paper. As paper thickness increases, 
move the lever toward the rear.

IMPRESSION CONTROL (PRINT INTENSITY ADJUSTMENT)

The Impression Control Switch provides three levels of print intensity 
(hammer energy) to accommodate print wheel font variations as well as for 
multiple copy forms.

LEVEL                   PRINT WHEEL FONT

Low                     Courier or light printing
Medium                  Prestige Elite, Madeleine Proportional Spacing
High                    Heavy printing, or multiple page forms

COVER SWITCH

A switch is incorporated on the front view cover. The printer will not 
operate if the front view cover is opened. Be sure to close the cover 
before you operate the printer.

CARD HOLDER RULED LINE

You can locate the printing position by using the ruled line (red) on 
the card holder. 


(smm 07/27/93)