DMP 2102 (260-2817)            Black Ribbon            Faxback Doc. # 4447

If the ribbon is already installed, simply check to see that it is properly
threaded between the paper and print head.

If the ribbon cassette is not installed, or if you need to replace it due 
to excessive wear or faint printing, follow this procedure:

1. Turn off the power switch.

NOTE: When you turn off the power, any information stored in the printer's 
buffer is automatically lost.

2. Open the access cover.

3. Position the print head between the bail rollers. Make sure the bail is  
   closed.

WARNING: The print head can get very hot during extended periods of print-
ing. Be sure to let the print head cool off before you touch it.

4. Remove the old ribbon cassette by grasping it at the arrow marks and 
   gently pull upward.

5. Unwrap the new cassette. Before inserting the new cassette, tighten the   
   ribbon by turning the ribbon feed knob in the direction of the arrow.

6. Hold the ribbon cassette with the ribbon feed knob facing up and the 
   flat end toward the front of the printer.

7. Place the flat end into the ribbon plate, then lower the front of the  
   cassette over the print head until it snaps into place.

8. Turn the ribbon feed knob in the direction of the arrow to take up the  
   slack in the ribbon.

9. Replace the access cover.

CAUTION: Printing without paper of ribbon can damage the print head or 
         platen.

(jlc-07/26/93)